Bennett HIGH FLOW H35, Instruction Manual

Page: 63 / 98

Programming
Bennett HF H35 Instruction Manual 59
STEP 2 – DETERMINE THE PULSE RATIO
The Pulse Ratio identifies the weight of each output pulse based on the pulse unit selected (mass display or money
display). As the pulse ratio increases, the minimum required pulse period increases. Follow the instructions below based
on the pulse unit selected in Step 1.
Pulses per Dollar (Decimal Mode 0) Pulses per Kilogram
100 1000
10 100
1 10
PULSE UNIT MONEY DISPLAY (OUTPUT) RATIO
PULSE UNIT MONEY DISPLAY (OUTPUT) RATIO OPTIONS
• 0 – Disabled
•
1 – 100:1 ratio
• 2 – 10:1 ratio
•
3 – 1:1 ratio
To select an Output Ratio for a Money Display Pulse Unit in Menu Code 50, follow this procedure.
1. After the Step 1 – Pulse Unit has been selected. The main display shows
the Pulse Output Ratio. The PPV display shows the dispenser is in Menu
Code 50.
If the dispenser has not been programmed since it came from the factory,
disabled appears in the main display. This is the default setting.
2. To change the setting, use the 0 through 3 buttons on the keypad to
enter a new option. Note : If an error is made, press the correct
number. The new number replaces the error.
3. When the correct option number appears in the mass display, press
the
Enter button to save the selection.
4. Proceed to Step 3 – Select the Pulse Period.
PULSE UNIT MASS DISPLAY (OUTPUT) RATIO
The Pulse Unit Mass Display (Output) Ratio options are shown below. Refer to Figure 50.4 .
KILOGRAMS – MASS DISPLAY OUTPUT RATIO OPTIONS
Figure 50.3 – Money Pulse Output Ratio
Sale $
P O R A T I O
Kilograms
1 0 t o 1
C O d e 5 0