Copiscan 8000 Spectrum Operator Manual
Figure 36. Pulling the Lamp Housing Out
To
clean
the lamps, follow the steps below:
1. Turn off the scanner.
2. Open the transport.
3. Open the side access panel of the scanner by folding it down to the left as you would
open the cover of a book. The operator-accessible areas of the scanner are now
exposed.
WARNING:
The lamps may be very HOT. Use precaution when changing the bulbs.
4. Remove the front-page lamp housing by grasping the black handle and gently pulling
it toward you.
5. Pull each lamp out carefully.
6. After the lamps are cool, use an optic cleaning pad to wipe the lamps until they are
free of dust.
7. Insert both lamps back into the housing.
8. Slide the lamp housing back in to the side frame of the scanner until it stops.
9. Repeat steps 4-6 to remove and clean the back lamps.
NOTE:
If after cleaning the lamps do not operate or the light source is still degraded, re-check
the position of the lamps and the housing(s). Improperly installed lamps are a common
source of these conditions. Replace lamps in pairs if necessary.
10. Close the side access panel and the transport.
11. Turn on the scanner.
66
www.bbhscanners.com
1-800-SCAN-494 Sales
1-800-SCAN-495 Technical Support
