Copiscan 8000 Spectrum Operator Manual
Figure 35. Feeder Sensor Location
6.11 Cleaning and Replacing the Lamps
NOTE:
When the user access panel is opened, a safety interlock removes power from the
transport motor.
WARNING:
The lamps may be very HOT. Use precaution when changing the bulbs.
The scanner lamps should be cleaned monthly (or as needed), and might need to be
replaced periodically
in pairs
. You may need to replace them when the control panel
displays the following messages:
•
“Check front lamps”
•
“Check back lamps”
•
“Low front lamp level”
•
“Low back lamp level”
Lamps are available for purchase individually (Part #S004868) and as part of the
Spectrum All-In-One Kit (Part #S005200) through Böwe Bell + Howell Authorized
Service Providers (ASPs), Consumable Parts Resellers (CPRs) and at
www.bbhscanners.com
. For a complete listing of ASPs and CPRs, please visit our
website at
www.bbhscanners.com
.
The simplex scanner has two individual lamps, and the duplex scanner has two pairs of
individual lamps—one pair per camera. All lamps can be replaced through the left user
access panel. For duplex operation, both the front and the rear lamps should be changed
at the same time for the best reliability.
65
www.bbhscanners.com
1-800-SCAN-494 Sales
1-800-SCAN-495 Technical Support
