Copiscan 8000 Spectrum Operator Manual
There are three main types of operator interface menus on the scanner, including the
home menu, user menus, and maintenance menus.
•
The home menu is normally displayed while scanning. It shows basic scanner
configuration information and scanning status.
•
The user menus allow the various scanner features to be tailored to the needs of the
customer.
•
The maintenance menus allow access to menus necessary for periodic calibration,
maintenance procedures, and for scanner software updates.
The control panel LCD will display one of the following main states:
Scanner State
Description
SCANNER INITIALIZING Going through the power up sequence
READY (Home Menu)
Waiting for a command from the host
LOAD PAPER
Paper not present in the feeder
SCANNING
Executing a host command
STOPPED
By error or stop request
ERROR PROCESSING
Trying to clear an error
COVER OPEN
Side access panel is open
The following seven subsections describe these states in more detail.
5.2.2.1 SCANNER
INITIALIZING
When you apply power to the scanner or request a reset through the application software,
the scanner goes through a power up sequence and a series of diagnostic routines. If a
scanner component fails, an error is displayed.
NOTE:
Errors displayed during initialization should be reported immediately to a Böwe Bell +
Howell service representative. Please refer to the Contact Information page in this
manual.
This is the first display after power-on or after a software reset. While this is displayed,
the machine performs a CRC check, flashing contents that verify the integrity of the
program code.
Initializing...
Copiscan SPECTRUM Series
If the CRC check passes, the following message is displayed for several seconds.
Initializing...
CRC OK
23
www.bbhscanners.com
1-800-SCAN-494 Sales
1-800-SCAN-495 Technical Support
