Copiscan 8000 Spectrum Operator Manual
5.3.3.1
Batch Size Selection
Batch Size:
Full
The feeder can be set to use two different batch sizes, Full and Small. Use the Full size
for feeding batch sizes of up to 500 documents, use the Small size for feeding batch sizes
of 100 documents or less.
To set the feeder batch size, follow the steps below:
1. From the home menu, press the RIGHT arrow key once.
2. In the BATCH SIZE menu, press either the + key or the – key to change the batch
size. When the Full size is selected, the feeder Elevator table will move to the full
down position. When the Small size is selected the feeder Elevator table will move up
to the Small batch size position.
3. After the appropriate batch size is selected, press the CLEAR button to return to the
home menu.
5.3.3.2
ADF, Manual, and Assisted Manual Modes
Select Feeder Mode
ADF MANUAL TEST
The scanner can be set in two different paper feeding modes, ADF (Automatic Document
Feed) mode and MANUAL FEED mode. Use ADF mode when you are feeding
documents that are similar in size, and weight. Use the MANUAL FEED mode when
feeding mixed batch applications, or documents that are different sizes and weights.
To set the scanner in
ADF Mode
, follow the directions below:
1. Make sure that the scanner is in the proper mode before scanning. It should say
AUTO FEED on the home menu. If it says MANUAL FEED instead of AUTO
FEED, press the RIGHT arrow key until you to get to the SELECT FEEDER MODE
menu.
2. In the SELECT FEEDER MODE menu, select F1 for ADF mode.
3. Lower the manual/autofeed lever on the feeder to the A position.
4. Lift the skimmer assembly.
5. Place the documents in the feeder.
6. Set the feeder guides to the proper width so that the documents are center-justified.
7. Push the skimmer assembly down.
8. Begin scanning procedures by following software application instructions.
30
www.bbhscanners.com
1-800-SCAN-494 Sales
1-800-SCAN-495 Technical Support
