Copiscan 8000 Spectrum Operator Manual
turned off in Manual and Manual Assisted mode. However, the parameters remain in
the same position as they were set when you return to ADF mode.
The scanner can be programmed to elicit an audible alarm and stop the machine, elicit an
audible alarm and continue scanning, or ignore when a multifeed is detected. Follow the
directions below to set multifeed detection parameters:
NOTE:
Settings are restored at power up. Setting these parameters sets the default behavior on
detection of a multifeed.
1. From the home menu, press the RIGHT arrow key until you reach the USER SETUP
menu. Press F3 NEXT until you reach the multifeed mode menu.
2. From the MULTIFEED MODE menu, press +/- to select STOP, NOTIFY, or OFF,
depending on what you wish to occur. Select STOP if you want the scanner to beep,
display an error message, and stop feeding paper when a multifeed is detected. Select
NOTIFY if you want the scanner to beep and display a warning message when a
multifeed is detected. The feeder continues to feed paper in this mode. Select OFF to
ignore multifeeds. No multifeed indication is given in this mode.
3. Press CLEAR to return to the home menu.
5.3.4 Setting the Multifeed Ignore by Size
You can set the maximum size of a multifeed that will NOT trigger a multifeed error
when scanning. This is used to scan documents with labels or stickers, or to scan
envelopes, while still having multifeed detection active.
To set the multifeed ignore by size, follow the directions below:
1. From the home menu, press the RIGHT arrow key until you reach the USER SETUP
menu. Press F3 NEXT until you reach the multifeed ignore by size menu.
Multifeed if >
NEXT
3.0"
2. Press +/- to set the multifeed ignore by size to the largest document overlap that will
scan without multifeed.
3. Press CLEAR to return to the home menu.
5.3.5 Setting the Doc Prep Level
In the 8125D models only, you can select the level of doc prep you want. Selecting
AVERAGE lowers the throughput slightly and thus avoids “stream feeding” problems
caused by excessive document skew at maximum throughput.
NOTE:
Increasing the hole size slightly decreases the throughput of the scanner.
33
www.bbhscanners.com
1-800-SCAN-494 Sales
1-800-SCAN-495 Technical Support
