For your safety
Version: 2.1
───
11
eXtended Transport System
Only use original packaging for further processing
When shipping, transporting, storing and packing, use the original
packaging or conductive materials. Conductive materials are foam
or aluminum, for example.
During operation
Observe the earthing concept
Special conditions need to be observed for the earthing of the XTS.
Be sure to read the chapter "Earthing of the supply", [
68].
Do not work on live electrical parts
Make sure the protective conductor is connected properly. Never
disconnect electrical connections while they are live. Only work on
the XTS when the voltage has dropped to < 10 V. Disconnect all
components from the mains and secure against reconnection!
Do not touch hot surfaces
Check cooling of the surfaces with a thermometer! Do not touch the
housing during and after operation. Allow the XTS to cool down for
at least 15 minutes after it is switched off.
Avoid overheating
Operate the XTS according to the technical specifications. Refer
here to the chapter: "Technical data". Provide for adequate cooling
and switch the XTS off immediately if the temperature is too high.
Do not touch rotating components
Do not touch any moving parts during the operation of the XTS. En-
sure that all parts / components on the machine / plant are firmly
seated!
After operation
Before working on components, make sure that they are de-en-
ergized
Carry out a voltage test and check all safety-relevant devices for
functionality. Secure the working environment and the control cabi-
net against inadvertent power-up. See chapter: "Decommissioning",
[
81].
