Baldor VS1GV21-1B, Installation & Operating Manual, Page: 149 / 204

Monitor and RTC Description 12-3 MN765
P# Type Name Unit Help
69 R/W APP LAYER ERROR
Application Layer Error. Application layer error code number. The last
error that occurred
70 USB TRANSACTIONS USB Transactions. Total number of USB transactions since start up
71 USB ERRORS USB Errors. Total number of USB errors since start up
72 TSK STATUS
Task Status. Runtime task overrun status. Bits correspond to tasks that
have overrun their time limit
73 TSK ID Task ID. First task that overran its time slot
74 TSK COUNT
Task Count. Total number of overruns for the first task to overrun its
time slot
75 Kp PACKETS Keypad Packets. Total number of processed keypad packets
76 Kp T-GAPS Keypad Gaps. Total number of keypad inter-packet time gap errors
77 Kp NAKs
Keypad NAKs. Total number of NAKs sent. High word are received
NAKs low word is transmitted NAKs
78 EST POWER kW
Estimated Power. - Drive power output estimated from measured
current and voltages. Units: KW
79 EST ENERGY kWH
Estimated Energy. - Delivered by drive. Estimated from measured
current and voltages. Units: kHW
80 EST COST $
Estimated Cost. - Cost of output energy delivered. Estimated from cost
of kWH unit parameter
81 R/W ACCESS KEY
Access Key. - Parameter security access key. Contact Baldor to decode
the key code
82 R/W KEYPAD SOFT VER Keypad Software Version. - Keypad software version string
83 AUTOTUNE TEST RE
Autotune test result. Use keypad back/forward keys to review results on
the keypad
84 AUTOTUNE TEST RE
Autotune test result. Use keypad back/forward keys to review results on
the keypad
85 CMD TYPE Command Type. Operating mode input signal command type
86 FPGA READ ERRORS FPGA Read Errors. Number of errors when reading FPGA since start up
87 FPGA WRITE ERROR
FPGA Write Errors. Number of errors when writing to FPGA since start
up
88 FPGA ALARM REG FPGA Alarm Register. Alarm Latch|Alarm Status of Powerbase FPGA
89 REFRESH REQUEST Refresh Request. - Refresh parameter list request from drive to host
90 PHASE 1 VOLTAGE V Phase 1(U) Voltage. - Phase U RMS voltage
91 PHASE 2 VOLTAGE V Phase 2(V) Voltage. - Phase V RMS voltage
92 PHASE 3 VOLTAGE V Phase 3(W) Voltage. - Phase W RMS voltage
93 CUSTOM UNITS CUSTOM Custom Units. - Shows production rates according to custom units.
94 POS REFERENCE CNT Position Reference. - Position Profiler's Current Target Position.
95 POS DEMAND CNT Position Demand. - Position Profiler's Current Position Demand.
96 POS ERROR CNT
Position Following Error. - Difference Between Position Demand and
Rotor Position.
97 POS COUNTER CNT Position Counter. - Actual 32-bit position of the encoder.
98 LV TEST FEEDBACK LV test feedback. - Gives feedback on state of test
99 LV TEST FE STATE Front End State. -Gives feedback on state of front end
100 ID Power Base ID. - Power Base ID Number. Set by factory
102 PROC ERROR % ER Process Error. - Process PID error signal
103 ANA1 REF % Analog Input 1 Reference. - Reference generated from analog input 1
104 ANA2 REF % Analog Input 2 Reference. - Reference generated from analog input 2
Table 12-1 Monitor Parameters Descriptions Continued