Baldor VS1GV21-1B, Installation & Operating Manual, Page: 148 / 204

12-2 Monitor and RTC Description MN765
P# Type Name Unit Help
33 LINE VOLTAGE V Line Voltage. - Estimated drive input line-to-line RMS voltage
34 RATED A/V V Rated Amps/Volt. - Nominal drive current scaling set at the factory
35 MOTOR POLES Motor Poles. - Calculated /entered number of motor poles
36 RUN TIMER HR Run Timer. - Accumulated drive run (non-idle) time in hours
37 ACTIVE ALARMS Active Alarms. - Number of currently active /simultaneous alarms
38 ACT ALARM CODE Active Alarm Code. - Currently active alarm code
39 ANA IN1 V
Analog Input 1. - Measured value of analog input #1 on terminal input
J1-2 and J1-1
40 ANA IN2 V
Analog Input 2. - Measured value of analog input #2 on terminal input
J1-4 and J1-5
41 ANA OUT1 V Analog Output 1. - Estimated value of analog output #1 on terminal J1-6
42 ANA OUT2 V Analog Output 2. - Estimated value of analog output #2 on terminal J1-7
43 OPTION1 Option 1. - Option board detected in option slot #1 (left slot)
44 OPTION2 Option 2. - Option board detected in option slot #2 (right slot)
45 FEEDBACK Feedback. - Feedback board detected in motor feedback board slot
46 DATE AND TIME Current Date and Time. - Real time clock current reading
47 DST STATUS DST Status. - Daylight Saving Time status: 0=Not Active 1=Active
48
MOTOR OVERLOAD
REMAINING
%
Current overload count remaining until a motor overload fault/overload
occurs
49
LAST MOTOR
OVERLOAD
REMAINING
% Last reading of motor overload left before power down
50
LAST DRIVE
OVERLOAD
REMAINING
% Last reading of drive overload left before power down
51 SPEED MEASURED RPM
Displays measured speed from encoder or resolver even if control type
is V/F or open vector
52 ACTIVE PARAM TBL Active Parameter Table. – Parameter table currently in use on the drive
53 EE VER
Power Base EEPROM Rev. - Power base EEPROM parameter revision
number. Set by factory
54 FPGA VER
Power Base FPGA Rev. - Power base FPGA revision control number.
Set by factory
55 ACC/DEC DEMAND Hz/SEC Accel/Decel Demand. - Current ramp rate used by the velocity profiler
56 ID CURRENT ID Current. - D axis measured current proportional to motor flux
57 ID DEMAND A ID Demand. - D axis demand current proportional to motor flux
58 IQ CURRENT A IQ Current. - Q axis measured current proportional to motor torque
59 IQ DEMAND A IQ Demand. - Q demand current proportional to motor torque
60 POWER FACTOR Power Factor. - Ratio of (real power)/(apparent power)
61 PHASE 1 CURRENT A Phase 1(U) Current. - Phase U current
62 PHASE 2 CURRENT A Phase 2(V) Current. - Phase V current
63 PHASE 3 CURRENT A Phase 3(W) Current. - Phase W current
64 VD DEMAND V VD Demand. - D axis voltage demand for setting up motor flux
65 VQ DEMAND V VQ Demand. - Q axis voltage demand for setting up motor torque
66 ELECTRICAL ANGLE °
Electrical Angle. - Electrical angle used to develop phased voltages to
the motor
67 MOTOR SPEED RPM Motor Speed. - Current speed of the motor
68 AT TEST DESC Autotune Test Description. - Description of current autotuning state
Table 12-1 Monitor Parameters Descriptions Continued