BADU Genio, Translation Of The Original Operation Manual, Page: 85 / 276

Installation
09|2019 EN 15
ATTENTION! The relay load must be observed for this! A pump
with too high a current consumption can damage the relay. An
additional contactor and motor protection must be installed. This
also applies for three-phase current pumps.
Relay 5
Backflushing NO (normally open)
Relay 6 Rinsing NO (normally open)
Relay 7 Emptying NO (normally open)
Relay 8 Circulation NO (normally open)
Relay load
AC3 250 V/2 A
AC1 250 V/10 A
Assignment of the digital inputs on the RasPI
Only use the 12 V from terminal X2:1-4 for digital inputs.
Maximum current load 200 mA.
I01
Chlorine canister empty message
I02 pH canister empty message
I04 Pressure switch
I05 Level switch
I06 Enable BADU Omni actuating drive
I07 Switch for emptying
I09 Button for attraction 1
I10 Button for attraction 2
I11 Button for attraction 3
I12 Factory settings (5 s)
X8 Fuses; 230 V power supply
X8:F1 (T 1.25 A) Fuse 5 V Raspberry Pi
X8:F2 (T 6.3 A) Fuse terminal strip X8:L; power supply unit
24 V
BADU Genio external wiring
Relay connection designation (left-middle-right) looking at the
screw terminal from the front.
Low voltage
Inputs for attractions when switched by piezo/PN switch
additionally to the app.
Button1/Attraction1
Conductor1 X2:1 (12V)
Conductor2 I09