BADU Genio, Translation Of The Original Operation Manual

Page: 105 / 276

Operation
09|2019 EN 35
7.7 pH value
The display on the user interface shows the actual value of the pH
value. The value should be between 6.8 and 7.2.
If a dot is displayed next to the actual value, this means that the
dosing pump is active and that pH-minus/plus is added to the
dose.
The pH dosing can be controlled by the button. The current pH
value is indicated. The nominal pH value can be set here. The last
calibration is also displayed.
The controller type can by set by the Parameters button at the
bottom of the screen. You can select between pH-minus and pH-
plus here. The deviation between the nominal value and the
actual value can be set here. If the value is greater/equal the
deviation, the filter pump is running at maximum speed. The
safety cut-out can also be controlled in minutes.
Depending on which controller type is selected, the corresponding
chemical canister pH-minus or pH-plus must match.