Avaya P330, Reference Manual

Page: 101 / 360

Chapter 2 Avaya P330 Layer 2 CLI Commands
Avaya P330 Reference Guide 83
Example:
set psu type
User level: privileged, supervisor.
Use the
set psu type
command to set the main power supply type (AC/DC) of
the module.
L
This command is not applicable to P330-ML switches, which determine the PSU
type automatically. This command is used to set the power supply types for
other P330 switches in the stack.
The syntax for this command is:
set psu type [AC|DC][module number]
Example:
set qos policy-source
User level: privileged, supervisor.
L
This command applies to the P334T-ML only when it is in device mode
"Layer2".
Use the
set qos policy-source
command to set the policy source (local or
policy server).
The syntax for this command is:
set policy source <source>
Example:
P330-N# set ppp incoming timeout 15
PPP incoming session will automatically disconnect after 15
minutes of idle time
P330-N# set psu type DC 3
Power supply type was changed to DC on module 3
source local or policy server
• The default policy source for the P334T-ML switch is
local
P330-N# set qos policy - source local
Done!