AutoGate Shield M30 Series, Installation & Operation Manual

Page: 59 / 60

1.800.944.4283 AutoGate Technical Support
Mar 6, 2019
59
2. Clear Open. Fill in both feet and inches above.
3. Safety: Check for the following:
 Customer advised the Shield is for vehicular traffic only. Separate pedestrian entry gate and
walkway.
 Set and tested Internal Entrapment operation.
 Warning placards placed in clear view on both sides of the Drop arm/gate (do not drill into Arm).
 Installed and verified external entrapment sensors (photo eye(s) and contact sensors).

Installed the Drop arm/gate guard to the back of the operator or fenced off this area restricting
pedestrians from standing in or entering this entrapment area.
 All access controls are a minimum of 6 ft. away from any system component (operator, bolsters,
Ddrop arm/gate, gate, gate guard, etc.).
 Identify any area a pedestrian or owner can be struck, entrapped, pinched, etc by this system
and take actions to mitigate injury through placement of entrapment protection means outlined in
this manual.
4. Electrical
4.1. Measure Input Voltage Checked  Initials:_____________
Single Phase: Check all that apply.  120V  208V  230V  50 Hz  60Hz
4.2. Grounding Checked  Initials:_____________
 NFPA 780 Standard for the Installation of Lightning Protection Systems.
 Solid copper ground rod: (5/8in diameter, 10ft length) driven into ground within 3ft of operator.
 Single length of un-spliced 6AWG Copper wire less than 3ft long attached to lug on operator
frame.
5. Accessories: Proper installation and operation of any lights, alarms, emergency access, heat matts, etc.
Checked  Initials:_____________
Notes or comments:_____________________________________________________________
_____________________________________________________________________________
_____________________________________________________________________________
SHIELD POST INSTALLATION CHECKLIST (con’t.)
CLEAR OPEN
________FT. _________IN.