AutoGate Shield M30 Series, Installation & Operation Manual

Page: 41 / 60

1.800.944.4283 AutoGate Technical Support
Mar 6, 2019
41
Monitored Open Edge
When activated, the Drop arm/gate will stop, (in less than 2 seconds), and then reverse and
go to a full close secured position. Drop arm/gate will remain closed until it receives an
“INTENDED” INPUT (Keypad/Reader/Push Button/Free Exit) or the board is manually reset
(Not from an Entrapment input).
Monitored Open Beam
When activated, the Drop arm/gate will stop, (in less than 2 seconds), and then reverse and
go to a full close secured position. Drop arm/gate will remain closed until it receives an
“INTENDED” INPUT (Keypad/Reader/Push Button/Free Exit) or the board is manually reset
(Not from an Entrapment input).
Monitored Programmable
Input 1 & 2
Choice of Open or Close direction by Menu, choice of Edge or Beam and then 10K or 2 wire
by Menu.
(Refer to PROGRAMABLE INPUT FUNCTIONAL descriptions for required action.)
Monitored Close Edge
When activated the first time, the Drop arm/gate will stop in less than 2 seconds, and re-
verse to full open and allow the ‘Timer To Close’ to be activated upon open limit. Upon the
second activation closing, before reaching the close limit, the Drop arm/gate will again stop,
(in less than 2 seconds), and reverse to full open and the ‘Timer To Close’ will be deactivat-
ed. The Drop arm/gate will remain at full open until an “INTENDED” INPUT is activated
(Keypad/Reader/Push Button/Free Exit) . The close command will close the Drop arm/gate
and clear the hold command. An ‘Open’ command or a “Reverse” command, (not the Close
Beam input) will trigger the reset of the ‘Timer To Close’ activation. Also, any of the action
buttons on the control board can activate the Drop arm/gate, (Close button will close Drop
arm/gate and the Open & Stop buttons will reset the ‘Timer To Close’ to be active).
Note: Upon the second activation before reaching the close limit, when the Drop arm/gate
is in the “HOLD” condition, any input that was being maintained at the time of the second
activation shall be ignored until the Drop arm/gate is enabled by a different input! If the
CLOSE EDGE remains activated, no input will release the Drop arm/gate for operation.
Monitored Close Beam
When activated, the Drop arm/gate shall stop in less than 2 seconds, and then reverse to
full open. The ‘Timer to close’ will become active only after all inputs are clear.