AutoGate Shield M30 Series, Installation & Operation Manual

Page: 26 / 60

1.800.944.4283 AutoGate Technical Support
Mar 6, 2019
26
1 3
4 2
Locking Pin “Pass by Clearance” is a minimum of
1/2” (required). Adjust by repositioning the operator if
necessary.
Preferred conduit location
Final Positioning of the System (Forklift still in place)
 Pull the gate down to the closed position. Push down on the linkage assembly to lock the Drop arm/gate
in the closed position.
 Adjust the operator to center the Drop arm/gate between the Bolsters
 Use caution and remove the T/M pin
 With the forklift still in place pull up on the Linkage Arm and manually move the Drop arm/gate up and
down to make sure there are no interferences and the arm can operate freely. Minimum clearance be-
tween the barrier yoke end Locking Pin and the yoke end bolster as the Locking Pin passes the top edge
of the bolster is 1/2” (see below)
 Lock Drop arm/gate down. Place T/M Pin in position #1. Remove forklift.
 Drill and install concrete anchor bolts (Four 3/4” x 12” wedge bolts provided) to fasten the operator to the
raised pad. You do not need to add any type of epoxy to the holes and tighten. They do not need to be
torqued.
(see below for anchor bolt locations on operator).
1/2” Clearance (minimum)
Anchor Bolt
Locations
PREPERATION, ATTACHING THE DROP ARM, & OPERATOR INSTALATION