When the display is turned off, an “OFF” will be lit at the lower right
corner of the display screen. This doesn't mean the display is POWER-
OFF, but only that the measurement readings will not be sent to the
display. This option will accelerate the measurement process because
there is no I/O delay. But turning off the display will not affect the
messages displayed from the RECALL, MENU and CONFIG operations.
You can send a message through the remote interface from your PC
terminal to the lower row display and will substitute the original
display.
Default
The display default is “ON”. The “On/Off” selected by you is stored in a
volatile memory and the default “ON” will be restored when the meter
is power-off.
How to control the display
You can control the display through the front panel operation or
through the remote interface operation. The remote interface operation
has higher priority over the front panel operation.
Front Panel Operation
Use the following steps to control the display: Press MENU button then
use
◁
and
▷
buttons to locate “SYSTEM” submenu. Press
ENTER to
select it, and then again use
◁
and
▷
buttons to locate “DISPLAY”
submenu. Press
ENTER to select it, and then find ON or OFF by using
◁
and
▷
buttons. Press ENTER on your selection.
The locations of the
buttons are shown with red rectangle frames in
Figure 4-26
.
Procedures: MENU
→
SYSTEM
→
DISPLAY
→
{ON|OFF}
98
