operations only.
How to select a remote interface
Press MENU and then use
◁
and
▷
to select INTERFACE. Then Press
ENTER on your choice of USB or GPIB interface.
How to set address when using GPIB
Press MENU and then use
◁
and
▷
to access INTERFACE. Select GPIB
to set address. Use
◁,
▷,
△
and
▽
to adjust the numbers to the
desired address. Press ENTER to set it.
4.1.10 Input Terminal Switch
Definition
You can select either the front input terminals or the rear input
terminals for your measurements. There are 5 input terminals in the
front panel as well as the rear panel. If the rear terminal is enabled the
REAR annunciator at the upper side will be shown.
Default
The default situation is the front terminals.
How to switch the terminals:
To switch between the front and the rear input terminals, press
“TERMINALS” switch button on the front panel. Please see the
following figure for the location of the switch. The location of the
button and terminals is shown with a red rectangle frame in
Figure 4-
7
.
70
