ATIKA ASP 10 TS-2, Original Instructions Manual

Page: 21 / 184

21
Possible faults
Before each fault elimination:

Switch off device.

Pull out power plug
Problem Possible Cause Remedy
Logs are not being split properly
(insufficient splitting performance) 
The log is not positioned correctly

The log exceeds the maximum
dimensions or the wood is too hard
for the performance of the machine

Splitting blade does not split log

Oil leak

Hydraulic pressure too low

Incorrect connecting lead (longer
than 10 m or too small cable cross-
section).

Reposition the log correctly

Cut the log to the required dimensions

Sharpen splitting blade, check for burrs or notches

Place a sheet of cardboard under the log splitter in
order to locate the leak. To correct the problem, re-
fer to the manufacturer

Check the oil level and add more oil if necessary
If the problem cannot be rectified, refer to the man-
ufacturer

Use the correct connecting lead
Splitting blade extends wobbling or
with strong vibrations 
Air in the circuit

Splitting column not sufficiently
lubricated or oiled

Open oil tank cap

Check the oil level and add more oil if necessary

Lubricate splitting column or oil with environmental-
ly friendly spray oil.
If the problem cannot be rectified, refer to the man-
ufacturer
Splitting blade does not extend 
Hydraulic pump defective

To correct the problem, refer to the manufacturer
Motor starts, but the splitting blade
does not extend 
Motor turns in wrong direction

Check the motor direction
Threephase: adjust the motor direction
Motor does not start 
No power supply.

2-phase mode in threephase mo-
tor.

Mains cable defective.

Electric motor defective

Check fuses.

Have fuse and lead checked by qualified electri-
cian.

Replace the connection cable or have it checked by
an electrician

To correct the problem, refer to the manufacturer
In case of further faults or inquiries please contact your local dealer.