Installation and Operations Manual
AT&T Proprietary (Internal Use Only)
—113—
Transmitters are learned via the repeater by tamper or power on actuation of the actual
transmitter (fault & restore in 2 seconds. (See list in basic specifications.)
1. Once a transmitter is learned the integral LED indicator blinks two (2) times
verifying that the transmitter has been learned by the repeater.
2. The repeater automatically exits the “Learn Mode.”
3. To learn additions transmitters, repeat Steps 1 and 2.
NOTE:
Key Fobs are always repeated and do not need to be learned into the Repeater
memory.
6.2.10.4 Determining the number of transmitters learned into the memory
1. Push and hold the “Learn” button.
2. Continue to hold the “Learn” button.
3. After approximately five (5) seconds the LED counts out the number of
transmitters learned by the repeater by blinking one (1) time for every transmitter
learned by the repeater.
Example
: Eight (8) blinks indicate that eight (8)
transmitters have been learned by the repeater.
4. Release the “Learn” button after the flashes start.
6.2.10.5 Erasing Transmitters from Memory
1. Push and hold the “Learn” button.
2. Continue to hold the “Learn” button.
3. After approximately five (5) seconds the LED counts out the number of
transmitters learned by the repeater by blinking one (1) time for every transmitter
learned by the repeater.
4. Continue to hold the “Learn Button.”
5. Approximately five (5) seconds after counting the number of transmitters learned
by the repeater, the LED blinks indicating that the memory has been erased
6. Release the “Learn Button.”
