Installing the Pipeline
Installation steps
2-24
Preliminary January 30, 1998
Pipeline Start Here Guide
Starting up the Pipeline
Position yourself so you can see the LEDs on the front panel of the Pipeline.
Warning:
You must perform the following steps in the order listed. Plugging
the power supply into the wall socket before plugging the power cable into the
Pipeline can create sparks, cause an electrical fire, or destroy the Pipeline.
1
Plug the power cord into the Power jack of the Pipeline.
Figure 2-21. Connecting the power cord to the Pipeline
2
Insert the AC power plug into an electrical outlet.
Because the Pipeline has no power switch, plugging in the power supply turns the
Pipeline on. After you plug in the Pipeline, it takes about a minute for it to be
ready to use. The status light on the front of the Pipeline labeled PWR comes on
immediately to indicate that the power is on.
The LED labeled CON comes on when you connect the Pipeline to its power
source, and goes off when the internal power-on self test (POST) passes.
