Artesyn AXP1440, Installation And Use Manual, Page: 126 / 156

FRU Installation
124 AXP1440 Installation and Use (6806800H23U )
6.5.2 Installing the Upper FTM
Procedure - Install Upper FTM
Have the correct FTM available and follow these steps to install the upper fan tray module.
1. While supporting the FTM, align the FTM carefully into the fan slot in the shelf and
slowly slide the FTM until the ejector handles engage; fully close the handles.
The FTM is connected when the assembly is firmly seated in the upper
backplane connector and the hot swap handle moves to the closed position.
2. Hand tighten both chassis retention screws at the same time to secure the FTM.
3. Hand tool tighten both chassis retention screws, alternating back and forth until hand
tight. The recommended torque settings is 0.56 N-m.
When the blue LED turns off, the fan is operating.
6.5.3 Removing the Lower FTM
Removal Procedure
Follow these steps and refer to the figure to remove the lower front fan tray module from the
shelf.
Using a Phillips screwdriver, loosen the two chassis retention screws.
4. Open the ejector handle and wait for the Blue LED to go solid and steady. This indicates
that the FTM is ready to be removed.
5. Open the ejector handle to a full open position.
Figure 6-3. Lower Front FTM Ejector Handles and LEDs