Artesyn AXP1440, Installation And Use Manual, Page: 120 / 156

FRU Installation
118 AXP1440 Installation and Use (6806800H23U )
6.2.3.2 Powered System
This section describes the installation and removal procedures for a SAM in powered systems.
Procedure - Install SAM in Powered System
To install a SAM in a powered shelf, proceed as follows:
1. Put on an ESD wrist strap.
2. Connect the strap to the shelf by attaching the front or rear ESD jack.
3. Insert the module into the shelf by placing the top and bottom edges of the board in
the card guides of the shelf. Ensure that the guiding module of shelf and board are
aligned properly. The alignment pin facilitates the insertion and prevents bent pins.
4. Slide the module into the shelf and rotate the ejector handle upward until it snaps into
place.
5. Wait until the blue LED is illuminated.
6. Screw in the captive screw hand tight. The blue LED blinks.
7. Wait until the blue LED is switched OFF. The switched off blue LED indicates that the
board is activated.
Procedure - Remove SAM from powered System
To remove a SAM from a powered system, proceed as follows:
1. Put on an ESD wrist strap.
2. Connect the strap to the shelf by attaching the front or rear ESD jack.
3. Unfasten the captive screw at the upper left hand corner of the face plate until the
module is detached from the shelf.
4. The blue LED blinks indicating that the module power down process is ongoing.
5. Wait until the blue LED is illuminated permanently.
Data Loss
Removing the module with the blue LED still blinking causes data loss. Wait until the blue
LED is permanently illuminated, before removing the module.