Artesyn AXP1440, Installation And Use Manual, Page: 119 / 156

FRU Installation
AXP1440 Installation and Use (6806800H23U) 117
6.2.3.1 Non-powered System
This section describes the installation procedure for the SAM in non-powered systems.
Procedure - Install SAM in Non-powered System
To install a SAM in a non-powered shelf, proceed as follows:
1. Put on an ESD wrist strap.
2. Connect the strap to the shelf by attaching the front or rear ESD jack.
3. Insert the module into the shelf by placing the top and bottom edges of the module in
the card guides of the shelf. Ensure that the guiding module of shelf and board are
aligned properly. The alignment pin facilitates the insertion and prevents bent pins.
4. Slide the module into the shelf and rotate the ejector handle upward until it snaps into
place.
5. Screw in the captive screw hand tight.
Procedure - Remove SAM from Non-powered System
To remove a SAM from a non-powered shelf, proceed as follows:
1. Put on an ESD wrist strap.
2. Connect the strap to the shelf by attaching the front or rear ESD jack.
3. Unfasten the captive screw at the upper left hand corner of the face plate until the
board is detached from the shelf.
4. Unlock ejector handle by pressing the handle and pull down. The SAM should start to
move out of the chassis. Do not force it. If the SAM does not move, it means the captive
screw is not fully unscrewed. Unscrew until loose and rotate the ejector handle down.
5. Remove the module from the shelf.
Use ESD
protection
Damage of Circuits
Electrostatic discharge and incorrect blade installation and removal can damage circuits
or shorten their life.
Before touching the blade or electronic components, make sure that you are working in
an ESD-safe environment.