Artesyn AXP1440, Installation And Use Manual, Page: 110 / 156

FRU Installation
108 AXP1440 Installation and Use (6806800H23U )
6.2.1.1 Installing the RTM
You can install the RTM into a system if the front blade is already installed or if it is not installed.
If the front blade is already installed, its payload has to be powered down first.
Procedure - RTM with Installed Front Blade
The following procedure describes the installation of the RTM. It assumes that your system is
powered. If your system is non-powered, you can disregard the blue LED and thus skip the
respective step. In this case it is a purely mechanical installation.
1. Locate the slot the RTM is to be installed into the shelf's rear which must be the same
as that of the front blade.
2. Open the lower handle of the front blade in order to power down its payload.
The blue LED on the front blade starts to flash. This indicates that the front
blade is informing the shelf manager about its desire to power down its
payload.
3. Wait until the blue LED on the front blade is ON.
This indicates that the front blade’s payload is powered down.
4. Make sure that the top and the bottom handles of the RTM are in an outward position
by squeezing the lever and the latch together.
5. Insert the RTM into the shelf by placing the top and bottom edges in the card guides
of the slot.