Artesyn AXP1440, Installation And Use Manual, Page: 125 / 156

FRU Installation
AXP1440 Installation and Use (6806800H23U) 123
6.5.1 Removing the Upper FTM
Procedure - Remove Upper FTM
Follow these steps and refer to the figures to remove the upper fan tray module from the shelf.
1. Loosen the retention screw to the chassis before loosening the ejector handle screw.
2. Pull the ejector handle outward to a slightly open position to disengage the hot swap
switch.
3. Watch for the blue LED to blink. When the blinking stops and the LED remains a solid
blue, the FTM is ready to be removed.
4. Open the ejector handle to a full open position.
5. Using the handle on the front of the FTM, slowly pull the FTM out of the shelf, while
supporting the bottom of the module with the palm of your hand.
NOTE: The module is heavy. Hold it securely.
Fans may continue to rotate after power is removed. Keep fingers away from the bottom
of the FTM enclosure.
Figure 6-2. Upper Rear FTM Ejector Handles and LEDs