Ontario Drive & Gear Limited www.odg.com
PH.(519)- 662-2840 FAX (519)- 662-2421
TR-9A
Argo Service Manual
Transmission
TR-38
TR-39
Reassembling the Transmission
IMPOR
IMPOR
IMPOR
IMPOR
IMPORT
T
T
T
TANT
ANT
ANT
ANT
ANT
Installing the correct Retaining Ring to each of the components during the assembly
of the Avenger transmission is extremely important. Small variances in retaining
ring sizes can make it difficult at first glance to distinguish these differences. This
could result with the improper placement of a retaining ring to a component.
Caution should also be observed with the 107-04 and 107-12 Retaining Rings. The
107-04(smaller), is used to secure each sun gear to the end of the Output Shafts
within the differential. The 107-12 (larger), is seated just above the Reverse Gear
Pinion on the Input Shaft Assembly. WHEN COMPARING THESE TWO THEY
ARE VERY SIMILAR IN SIZE. IF IN DOUBT, A MEASUREMENT SHOULD BE
TAKEN.
The 107-02 Retaining Ring is installed to one side of the High Gear Pinion on the
Input Shaft assembly, while the 107-10 Retaining Ring is installed on the other side.
The one Retaining ring is slightly larger. Ensure that each is installed to the correct
retaining ring seat according to the instructions outlined on the following pages.
35. Remove all remaining Retaining Rings, Bearings and Seals from both the left and
righthand side housings.
36. Wash and soak all components in a degreasing bath before inspection.
