Argo Service Manual Clutch System
Ontario Drive & Gear Limited www.odg.com
PH.(519)- 662-2840 FAX (519)- 662-2421
CS-9
On vehicles manufactured from serial numbers CB14236, RB14121, BF9347,
SN9551, S9596 and all R, B, N, C & A Models(Cap Screw Spring Cap)
1.
Remove the nut and flat washer securing the cap to the fixed face pulley.
Photo CS-12
CS-12
CS-13
3.
Remove the 3 socket head cap screws securing the spring cover to the moveable face
pulley. Photo CS-14 Be aware of the small locking style flat washers that are
installed with each cap screw. Be sure these are reinstalled during assembly.
The cap screws should be loosened a little at a time in an alternating pattern. This
will ensure that the cap will not bind when coming off under spring tension. SEE
WARNING FOLLOWING PAGE
IMPORTANT
CS-10
CS-11
12. Wash clutch components in a clean varsol bath to eliminate accumulated dirt and
grease build up, and perform the servicing procedure, Inspecting the Driver
Clutch, in this section of the service guide
Disassembling the Driver Clutch (Cap Screw Spring Cover)
2.
Lift the cap to expose the blocks and weights and remove all three. Photo
CS-13
