Brake System
Argo Service Manual
Ontario Drive & Gear Limited www.odg.com
PH.(519)- 662-2840 FAX (519)- 662-2421
BR-17
2.
Inspect the condition of the piston. Replace the piston immediately if it is:
3.
Slide the primary and secondary seals off the piston. Discard these old seals.
Do not scratch the piston when removing the seals.
Models manufactured after May 25, 2000 from S/N CB17145, RB17120, BF11608
and SN11630 have a tapered spring which attaches to the end of the piston. Models
prior to this had a shorter spring which did not attach to the piston. The newer
spring is fully exchangeable with the older style but should be replaced as a set.
Master Cylinder Servicing & Inspection
1.
Thoroughly inspect all components of the master cylinder assembly and replace any
worn, cracked or broken parts.
Use only genuine ARGO parts
4.
Clean all components with alcohol or a mild soap solution. Use compressed air to
blow out the master cylinder castings. This will free up any dirt or other contami-
nants you could not reach with the cloth.
Scratched
Pitted
rusted
scored in any way
