Argo Service Manual Vehicle Body
Ontario Drive & Gear Limited www.odg.com
PH.(519)- 662-2840 FAX (519)- 662-2421
VB-5
3.
Remove the 2 steering adjustment locknuts and lay the steering levers back against
the driver's seat.
4.
Remove the fasteners securing the firewall to each side of the lower frame assembly.
Refer to your illustrated parts manual for firewall design and hardware breakdown.
5.
Pull the firewall from the vehicle grabbing from the bottom of the firewall and pull-
ing into the drivers compartment.
6.
Lift up and out from the vehicle.
On 6x6 Vanguards produced from S10769:
1.
Remove the front floor pan assembly. Pull the clevis pin from each side of the floor
pan and pull the floor pan up and out from the vehicle.
2.
Loosen off the 2 steering adjustment locknuts to allow enough steering handle travel
for the firewall to be pulled up and out from the vehicle.
3.
Undo the firewall at the dash support. The firewall is secured by 2 quick release
wingstuds.
4.
Remove the firewall from the vehicle.
Installing the Firewall(6x6 Vanguards)
On 6x6 Vanguards produced prior to S8131:
1.
With the steering levers pulled back against the drivers seat, install the firewall into
the vehicle aligning the mounting holes of the firewall, with those in the lower frame
assembly, and the T nuts in the lower body.
2.
Fasten the firewall at 4 locations as shown in the appropriate illustrated parts manual
using the listed hardware.
3.
Reconnect the steering levers at the brake cams and re-thread the nylon locknuts to
the steering rods.
5.
Perform the servicing procedure, Steering Lever Adjustment, in section BR of this
service guide.
6.
Install the shift knob.
7.
Install the floor pan.
2.
Unthread the shift knob from the lever & remove the twist grip throttle from the right
steering lever.
4.
Reinstall the twist grip assembly to the right hand steering lever.
