Argo Service Manual Wheels, Axles & Chains
Ontario Drive & Gear Limited www.odg.com
PH.(519)- 662-2840 FAX (519)- 662-2421
Removing the Front Axle (Avenger Model)
1.
Raise the vehicle off of the ground.
3.
Remove the firewall.Turn the quick release fastener located at the top of the
firewall. Pull the top of the firewall rear-
ward and into the drivers compartment.
2.
Remove the front tire.
4.
Remove the front floor pan
5.
Optional: If you wish to remove the
drive belt and driven clutch, it may
prove easier to access the inner axle
bearing, and in general, provide a
roomier working environment. Refer to
the Clutch Section of the 673-04 Argo
Service Guide
.
7.
Remove the drive chain between front sprocket and idler shaft sprocket.
Photo WA-1
Refer to Drive Chain Removal in the 673-04 Argo Service Guide.
8.
Remove the inner axle fastener and washer located at the inner bearing on the axle
end. Photo WA-2
WA-1
WA-2
WA-3
For ease of removal, place the closed end of the wrench at the fastener head while turning
the axle at the wheel hub on the outside of the vehicle. Photo WA-3
WA-50A
