Argo Service Manual Wheels, Axles & Chains
Ontario Drive & Gear Limited www.odg.com
PH.(519)- 662-2840 FAX (519)- 662-2421
WA-7
ii.
Roll the vehicle until the connecting link on one of the chains is visible.
iii.
Remove the spring clip from the connect-
ing link as shown in WA-3 (previous
page) Remove the outside plate and tap
out the connecting link. The inside plates
will be released when the connecting link
is removed (Frt. & Mid Frt. RC50 Chains
Only). The rear chain drive is single
RC60 and has no inside plates.
Photo WA-6
Drive Chain Removal
On 8x8 models manufactured from serial numbers CB16049 & RB16104, or
6x6 models from serial numbers BF9212, SN10191 & S10178:
i.
Turn the tensioner cam assembly in the direction which winds up the torsion spring
and push the assembly down as close as possible to the cam follower block in the
bottom of the frame. Secure it in this position with a Vice-Grip 10CR as illustrated
in DIAGRAM WA-5.
WA-5
Drive Chain Inspection
The drive chains will stretch and wear after
extensive vehicle use, and cause a reduction in vehicle performance and a hazard to
personal safety. Roller chain “stretch” results from wear to the chain pins and bushings
because of the loss of lubricant.
the chain tensioner system can no longer take up the slack
the chain is seized up, corroded or rusted
the chain is causing damage to the sprockets
WA-6
iv.
Remove the chain from the vehicle.
v.
Repeat steps 4 to 6 until all drive chains
are removed if necessary.
2.
Inspect the drive chains and replace, or remove a link and install a half link if enough
chain stretch will allow it. Perform any of the above procedures if:
1.
Remove the front and rear floorpans.
3.
Perform the servicing procedure, Drive
Chain Inspection below.
