Vehicle Body Argo Service Manual
Ontario Drive & Gear Limited www.odg.com
PH.(519)- 662-2840 FAX (519)- 662-2421
VB-4
Installing the Firewall(Conquest, Response, Bigfoot & Vanguard2)
1.
Place the firewall into the drivers compartment and temporarily route the throttle
cable into the area provided for the cable grommet. Photo VB-4
2.
Slip the top of the firewall between the upper body plastic and the metal dash brace.
Photo VB-5
3.
Push the firewall in at the bottom and snap in securely with the wing fastener.
VB-4
VB-5
4.
Assemble the throttle cable grommet to the firewall.
Removing the Firewall (6x6 Vanguards)
On 6x6 Vanguards produced prior to S8131:
1.
Remove the front floor pan assembly. Pull the clevis pin from each side of the floor
pan and pull the floor pan up and out from the vehicle.
3.
Remove the 2 steering adjustment locknuts and lay the steering levers back against
the driver's seat.
4.
Remove the fasteners on each side of the firewall at the lower frame assembly. Refer
to your illustrated parts manual for firewall design and hardware breakdown.
5.
Remove the 2 fasteners securing the firewall into the T nuts at the lower body.
6.
Remove the firewall.
On 6x6 Vanguards produced from S8131 and prior to S10769:
1.
Remove the front floor pan assembly. Pull the clevis pin from each side of the floor
pan and pull the floor pan up and out from the vehicle.
2.
Unthread the shift knob from the lever & remove the twist grip throttle from the right
steering lever.
