Wheels, Axles & Chains Argo Service Manual
Ontario Drive & Gear Limited www.odg.com
PH.(519)- 662-2840 FAX (519)- 662-2421
WA-44
6.
Remove the tire from the axle.
7.
Pull the axle from the vehicle. If necessary use a soft faced mallet to knock the axle
at the hub, from behind. Photo WA-102
9.
Remove the axle assembly to a clean work bench for further disassembly
10. Remove gaskets and flanges.
11. Remove the set screws of the outer bearing and slide the bearing from the axle. If
the bearing does not slide off freely, an arbor press may be needed. Photo WA-103
12. Remove the greasable flange.
Removing the Axle Seals
1.
Perform the servicing procedure,
Removing the Axle (With bearing
Ext.) or (Without Bearing Ext.)
2.
Remove the seals from the greasable
flange using a hammer and drift
punch. Photo WA-104
6x6 Vanguards manufactured prior to S/N S7447 have only a single seal in the outer
bearing greasable flange. Later 6x6 models,as well as all other models, have 2 grease
seals in the outer bearing greasable flange. Single seal outer bearing greasable flanges
are no longer available and must be updated to the to the double seal if replaced.
8.
Retrieve the drive sprocket from inside the vehicle once the axle has been
completely removed from the vehicle.
WA-102
WA-103
WA-104
