Name
Range
Step Default
Description
Input value 2
0...4000
0.000
01
1
The measured input value at Curve Point 2.
Scaled output
value 1
-10
7
...10
7
0.000
01
0
Scales the measured milliampere signal at Point 2.
Add
curvepoint
3...20
0: Not
used
1: Used
-
0: Not
used
Allows the user to create their own curve with up to twenty (20) curve
points, instead of using a linear curve between two points.
5.5.11 Logical outputs
Logical outputs are used for sending binary signals out from a logic that has been built in the logic
editor. Logical signals can be used for blocking functions, changing setting groups, controlling digital
outputs, activating LEDs, etc. The status of logical outputs can also be reported to a SCADA system.
64 logical outputs are available. The figure below presents a logic output example where a signal from
the circuit breaker failure protection function controls the digital output relay number 5 ("OUT5") when
the circuit breaker's cart status is "In".
Figure. 5.5.11 - 185. Logic output example. Logical output is connected to an output relay in matrix.
Logical output descriptions
Logical outputs can be given a description. The user defined description are displayed in most of the
menus (logic editor, matrix, block settings etc.).
Table. 5.5.11 - 288. Logical output user description.
Name
Range
Default
Description
User editable
description LOx
1...31
characters
Logical
output x
Description of the logical output. This description is used in several menu
types for easier identification.
Genera
Generattor Commander
or Commander
Instruction manual
Version: 2.07
358
© Arcteq Relays Ltd
IM00001
Summary of Contents for Generator Commander
Page 1: ...Generator Commander Instruction manual...
Page 2: ......
