DELUXE FACESHIELD
MODEL NO:
SSP80
Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT:
PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
1. SAFETY
9
Use of this face shield is for face and eye protection against low energy impact and splashing liquids.
9
Inspect the face shield frequently as a pitted or scratched face shield reduces vision and therefore should be replaced immediately.
9
When necessary, use identical replacement parts contact your Sealey stockist.
9
Use in an environment between -5°C and +55°C.
9
Be aware if wearing standard opthalmic spectacles they may transmit impacts, creating a hazard for the user.
8
DO NOT
use if any part of the face shield is cracked or broken.
8
DO NOT
place this product on a hot surface.
8
DO NOT
use this faceshield for protection against fine dust, gas, ultra violet or infra red radiation, ionising radiation, liquids under
pressure or other severe hazards.
8
DO NOT
use this face shield against heavy impact hazards, the lens is breakable.
8
DO NOT
use this face shield for welding, laser cutting or grinding.
2. INTRODUCTION
Ratchet adjustable headband with front and back padding for extra comfort. Polycarbonate visor for increased protection, stability and
durability. Stepped angle adjustment on visor which simply flips up out of the way when not in use. Suitable for use with standard glasses.
Premium quality for automotive, agricultural and industrial applications. Conforms to BS EN 166.
3. SPECIFICATION
MODEL NO: ...............................................................SSP80
Consumable Parts: ................. SSP80R - Replacement Visor
Lens Type: .................................................................... Clear
4. COMPONENTS
Refer to fig.1
4.1.
The faceshield is supplied assembled. Refer to diagram
for location of individual components.
Visor (1), Frame (2), Headgear parts (3)
5. ADJUSTING THE MASK
Refer to fig.2
5.1.
In use ensure the visor sits comfortably over the face.
5.2.
Circumference Adjustment: by pushing and turning the
thumbwheel at the back of the head band.
5.3.
Adjust top of head band by releasing poppers.
5.4.
Tilt adjustment: pull levers outwards on each side.
5.5.
Forward/backward adjustment: release thumbwheels
to allow adjustment.
6. MAINTENANCE
6.1.
CHANGING THE VISOR
6.1.1.
Release the stud from the bottom of the outside front of the
faceshield.
6.1.2.
Release the two tags on the outside bottom edge of the
visor.
6.1.3.
Release the two sides and pull downwards to release the
visor.
6.1.4.
Fitting a new visor is the reverse of the above.
6.2.
CLEANING AND DISINFECTION
8
DO NOT
use abrasive materials.
fig.1
fig.4
Original Language Version
© Jack Sealey Limited
Refer to
instructions
SSP80 Issue 1 19/08/2020
fig.1
fig.2
