Arcteq Generator Commander, Instruction Manual

Page: 400 / 561

Figure. 5.6.6 - 208. Effects of recording length and pre-triggering time signals. This example is based on the settings shown
above.
When there is at least one recording in the device's memory, that recording can be analyzed by using
the AQviewer software (see the image below). However, the recording must first be made accessible to
AQViewer. The user can read it from the device's memory (
Disturbance recorder
→
Get DR-
files). Alternatively, the user can load the recordings individually (Disturbance recorder
→
DR List) from
a folder in the PC's hard disk drive; the exact location of the folder is described in Tools
→
Settings
→
DR path.
The user can also launch the AQviewer software from the Disturbance recorder menu. AQviewer
software instructions can be found in AQtivate 200 Instruction manual ( arcteq.fi./downloads/ ).
Events
The disturbance recorder function (abbreviated "DR" in event block names) generates events and
registers from the status changes of the function: the recorder generates an event each time it is
triggered (manually or by dedicated signals). Events cannot be masked off. The user can select which
event messages are stored in the main event buffer: ON, OFF, or both.
Table. 5.6.6 - 330. Event messages.
Event block name Event names
DR1 Recorder triggered ON
DR1 Recorder triggered OFF
DR1 Recorder memory cleared
DR1 Oldest record cleared
DR1 Recorder memory full ON
DR1 Recorder memory full OFF
DR1 Recording ON
DR1 Recording OFF
DR1 Storing recording ON
DR1 Storing recording OFF
DR1 Newest record cleared
Genera Generattor Commander or Commander
Instruction manual
Version: 2.07
398 © Arcteq Relays Ltd
IM00001