2
Unpacking the 1133A
1.3
Unpacking and Locating Accessories
The Model 1133A and included accessories are packed between two closed-cell foam shells. Carefully
pull apart the two shells to extract the 1133A and accessories. Some of the accessories (i.e. antenna
and rack-mount ears) are located in one of these shells for protection. In the diagram below, you
can see how the GNSS antenna and rack-mount ears are located in the closed-cell foam marked
with the label that reads,
ADDITIONAL PARTS INSIDE
Figure 1.1: Packaging of Accessories
Antenna cable, 1133A and setup guide are located between the two pieces of closed-cell foam.
The rack-mount ears and antenna are embedded in the packing foam side labeled
ADDITIONAL
PARTS INSIDE.
1.4
Attaching Rack-Mount Ears to 1133A
Each Model 1133A comes with two rack-mount ears suitable for mounting in a 19-inch system
rack. These ears have four mounting holes, two of which are used to attach them to the sides of
the 1133A. Since it is required to remove the M25 screws which attach the cover to the chassis, it
may be good to attach the ears after first making any configuration changes inside the 1133A.
You
will want to return to this section after making these changes.
Mounting Instructions
1. Using a Torx T25 driver or large slot screwdriver, remove the four M25 screws attaching the
1133A cover to the chassis. Use either a T-25 or large slot screwdriver.
2. With the ear facing out from the front panel (see Figure 1.2), match the lower set of holes of
the ear to the cover/chassis and remount the M25 screws.
3. Repeat this procedure with the other side of the chassis and other ear.
