![background image](http://html1.mh-extra.com/html/amx/modero-nxd-cv17/modero-nxd-cv17_operation-reference-manual_2938955079.webp)
Upgrading Modero Firmware
69
CV17 17" Modero Coor Video Touch Panels
Upgrading Modero Firmware
Before beginning the Upgrade process:
Setup and configure your NetLinx Master. Refer to your particular NetLinx Master instruction
manual for detailed setup procedures.
Calibrate and prepare the communication pages on the Modero panel for use. Refer to the
Panel
Calibration
section on page 47.
Refer to the NetLinx Studio version 2.4 or higher Help file for information on uploading files via
Ethernet.
Configure your panel for either direct connect or wireless communication. Refer to the
Configuring
Communication
section on page 49 for more detailed information about Ethernet, ICSNet, or
Wireless communication.
The process of updating firmware involves the use of a communicating NetLinx Master. The required steps for
updating firmware to a Modero panel are virtually identical to those necessary for updating KIT files to a
NetLinx Master (
except the target device is a panel instead of a Master
). Refer to either your Master’s
literature or Studio 2.4 Help file for those procedures.
Upgrading the Modero Firmware via an IP Address
Before beginning with this section, verify that your panel is powered and connected to the NetLinx Master
through an Ethernet connection (direct or wireless).
Preparing the Master for communication via an IP
1.
Obtain the IP Address of the NetLinx Master from your System Administrator, if you do not have an IP
Address for the Master, refer to your particular Master’s instruction manual for more information on
obtaining an IP Address using NetLinx Studio 2.4 or higher.
From the
Online Tree
tab of the Workspace window, select the NetLinx Master.
Follow steps outlined in either the
Obtaining or Assigning the Master’s IP Address
sections from
your particular NetLinx Master instruction manual to use an address.
Note the IP Address and Gateway information.
2.
Launch NetLinx Studio 2.4 (default location is
Start
>
Programs
>
AMX Control Disc
>
NetLinx
Studio
>
NetLinx Studio 2.4
).
3.
Select
Settings
>
Master Communication Settings
, from the Main menu to open the Master
Communication Settings dialog (FIG. 66).
It is recommended that firmware KIT files only be transferred over a direct Ethernet
connection and only when the panel is connected to a power supply.
If battery power or wireless connection fails during a firmware upgrade, the panel
flash file system may become corrupted.
A touch panel which is not using a valid username and password will not be able to
communicate with a secured Master. If you are updating the firmware on a panel
which is not using a username or password field, you must first remove the Master
Security feature to establish an unsecured connection.
Summary of Contents for modero NXD-CV17
