AMX modero NXD-CV17, Operation/Reference Manual

Page: 27 / 168

CV17 Touch Panel Accessories
17 CV17 17" Modero Coor Video Touch Panels
Step 2: Installing the Upgrade Compact Flash Card
1.
Discharge any static electricity from your body by touching a grounded metal object.
2.
Locate the 128 MB Compact Flash card on the main board (for more detailed information on component
locations (FIG. 18).
3.
Insert a grounded flathead screwdriver into one of the card removal grooves (located on either side of the
card), and gently pry the card up and off the connector pins (FIG. 18). This alternating action causes the
card to "wiggle" away from the on-board connector pins.
4.
Slip your finger into the opening between the connector pins and the card, and push the card out to
remove it.
5.
Remove the upgrade card from its’ anti-static bag.
6.
Insert the upgrade card into the connector opening with the arrow facing towards the pins, then push it in
firmly until the contact pins are completely inside the Flash Card and securely attached to the connector.
Step 3: Replacing the NXT Outer Housing
1.
With the card securely installed, tilt the LCD back to a 45° and then gently slide-on the outer housing
(towards the LCD) until the it is aligned over the installation holes and the tilt bracket prevents any further
forward movement (FIG. 17).
2.
Gently press down on the housing (toward the base) until it is securely positioned over the circuit board
and covers base.
3.
While holding the outer housing and base plate in place, turn the panel back over until the LCD lies
facedown on a soft cloth and the under-side of the base is exposed.
4.
Insert and secure the eight Housing Screws (using a grounded Phillips-head screwdriver) into their
respective locations (FIG. 16 on page 15).
5.
Grasp both the LCD and housing, then rotate the entire unit back onto a flat surface then insert all
connectors and apply power.
FIG. 18 Removing the Compact Flash card
Under-side indention
located below
Insert with arrow
facing towards the pins
On-board Compact
Flash connector
A new internal card upgrade is detected by the panel only after power is cycled.