![background image](http://html1.mh-extra.com/html/amx/modero-nxd-cv17/modero-nxd-cv17_operation-reference-manual_2938955053.webp)
Installation
43
CV17 17" Modero Coor Video Touch Panels
Wiring Guidelines for the 17" Panels
The panels require 12 VDC power from a PSN6.5 NetLinx Power Supply to operate properly. The panels
connect to the power supply via a 2-pin 3.5 mm mini-Phoenix connector.
Preparing captive wires
You will need a wire stripper and flat-blade screwdriver to prepare and connect the captive wires.
1.
Strip 0.25 inch (6.35 mm) of insulation off all wires.
2.
Insert each wire into the appropriate opening on the connector (according to the wiring diagrams and
connector types described in this section).
3.
Tighten the screws to secure the wire in the connector.
Do not tighten the screws excessively; doing so
may strip the threads and damage the connector.
Using the PSN NetLinx connector for power
The PWR and GND cable from the NetLinx Power Supply (PSN4.4 or PSN6.5) must be connected to the
corresponding location on the 2-pin 3.5 mm mini-Phoenix connector (FIG. 43).
1.
Insert the PWR and GND wires on the terminal end of a PSN 2-pin 3.5 mm mini-Phoenix cable.
Match
the wiring locations of the +/- on both the power supply and the terminal connector.
2.
Tighten the clamp to secure the two wires.
Do not tighten the screws excessively; doing so may strip the
threads and damage the connector.
3.
Verify the connection of the 2-pin 3.5 mm mini-Phoenix to the power supply.
ICSNet RJ-45 Connections/Wiring
The following tables show the signal and pinout/pairing information used for ICSNet data connections.
ICSNet uses a standard CAT5 Ethernet cable to provide communication between the touch panel, Breakout
Box, and NetLinx Master.
These units should only have one source of incoming power. Using more than one
source of power to the touch panel can result in damage to the internal components
and a possible burn out.
Apply power to the panels
only after
installation is complete.
Never pre-tin wires for compression-type connections.
FIG. 43
NetLinx power connector wiring diagram
ICSNet RJ-45 Signals
Pin
Signal-Master
Signal-Panel
1
TX +
RX +
2
TX -
RX -
3
N/A
N/A
4
GND
GND
5
N/A
N/A
6
N/A
N/A
7
RX +
TX +
8
RX -
TX -
PWR +
GND -
To the Touch Panel
PSN Power Supply
Summary of Contents for modero NXD-CV17
