![background image](http://html1.mh-extra.com/html/amx/modero-nxd-cv17/modero-nxd-cv17_operation-reference-manual_2938955037.webp)
Installation
27
CV17 17" Modero Coor Video Touch Panels
Installation
Overview
NXT panels are mounted onto flat (horizontal) surfaces in either a stand-alone or combo (NXT atop an NXA-
BASE/B battery base) configuration. NXD panels are installed into either a pre-wall surface (using the CB-
TP17 conduit/wallbox) or a solid surface (using either solid surface or drywall screws).
Unpacking the Panel
1.
Inspect and confirm the contents of the shipment box to verify that you have all specified parts. Refer to
the
Specifications
sections on page 2 for more information about included and optional accessories.
2.
Carefully remove the panel from the shipping box.
3.
Carefully peel the protective plastic cover from the LCD.
Installing the Internal Components
Installation of the internal components such as the Compact Flash and wireless card are described in detail
within the following sections:
Installing the wireless card
section on page 14.
Installation of the Compact Flash Card (Table Top Panel)
section on page 15.
Upgrading the Back Box with the MB-TP17 VESA Housing
Upgrading the existing back box with the new VESA Mounting Kit (
FG033-50
) requires 3 main processes:
Removing the pre-existing back box and installing the new VESA back box.
Threading cables through the strain relief grommet opening in the rear plastic cover.
Finalizing the installation of the NXD (with VESA back box and cables) into the plastic cover,
securing both components, and finalizing the strain relief grommet installation.
Removing the Original Modero Back Box
1.
Detach all connectors from the side of the touch panel.
2.
Remove the magnetic faceplate from the NXD-CV17 unit by gripping the faceplate and pulling outwards
while applying a small amount of pressure to remove it from the main unit.
3.
Place the LCD face-down on a soft cloth to expose the back of the panel and prevent scratching of the
LCD.
4.
Unscrew the nut from the Stereo Output jack.
5.
Remove the I/O connector plate by using a grounded Phillips-head screwdriver to turn the two screws and
slide the I/O connector plate away from the back box housing.
6.
Remove the four pan-head Housing Screws from the rear of the NXD unit (FIG. 30). These screws secure
the back box to the internal panel casing.
If the protective plastic LCD cover is not removed, the panel may not respond
properly to touch points on the LCD or allow proper screen calibration.
The new MB-TP17 Universal VESA Mounting Box uses a standard VESA installation
pattern of 75 mm between holes. VESA mounts that conform to this pattern can be
used on the MB-TP17 Housing.
DO NOT REMOVE THE PANEL SECURING SCREWS
. These screws secure the
LCD to the metallic casing.
Summary of Contents for modero NXD-CV17
