AMX modero NXD-CV17, Operation/Reference Manual

Page: 43 / 168

Installation
33 CV17 17" Modero Coor Video Touch Panels
Installation of an NXD-CV17
The NXD-CV17 can be installed either directly into the (optional) CB-TP17 or other solid surface
environment using the two different mounting options: drywall clips or solid surface screws. The following
sections describe mounting the touch panel directly into an installed pre-wall Conduit Box, a solid surface or
drywall, and optional NXA-RK17 Rack Mount Kit.
Installing the NXD-CV17 within a CB-TP17 Conduit Box
The conduit box must be mounted prior to continuing this section. Refer to the procedures in the Pre-wall
Installation of the CB-TP17 Conduit Box section on page 31 for detailed pre-wall installation instructions.
Verify that all necessary cables have been threaded through the knockouts on the conduit box and the
connections have been tested prior to installation of the NXD-CV17.
1.
Remove the magnetic faceplate/bezel ( A in FIG. 36) from the main NXD unit ( B in FIG. 36) by gripping
the faceplate and pulling with gentle outward force.
2.
Verify the incoming RJ-45, Ethernet, and any other audio/video cables have been properly threaded
through the wiring knockouts on the left of the conduit box. Leave enough slack in the wiring to
accommodate any re-positioning of the panel.
3.
Connect all data and power wiring connectors to their corresponding locations along the side of the (un-
powered) NXD touch panel.
Verify the terminal end of the power cable is not connected to a power supply before plugging in the
2-pin power connector.
4.
Test the incoming wiring by connecting the panel connections to their terminal locations and applying
power. Verify the panel is receiving power and functioning properly to prevent repetition of the
installation.
FIG. 36 Wall Mount panel installation configuration of a CB-TP17 in a pre-wall construction
B - Main NXD unit consists of
C - Optional CB-TP17
Mounting Screws
(not included)
secure the NXD to
Stud
the touch panel and backbox housing
conduit/wallbox
Support block
Mounting Tab
Do not use these
tabs to mount
the conduit /wallbox
These are ONLY used to
secure the main unit to the CB
A - Faceplate
(bezel)
the Conduit Box
Four #8 flat-head
Don’t disconnect the connectors from the touch panel. The unit must be installed with
the attached connectors before being inserted into the conduit box.