AMX modero NXD-CV17, Operation/Reference Manual

Page: 40 / 168

Installation
30 CV17 17" Modero Coor Video Touch Panels
6.
Securely grasp both sides of the NXD panel (with LCD, MB-TP17 back box, and attached cables), rotate
the entire unit over, and lie it on a flat level surface.
7.
Note the available mounting contact surface area on the rear plastic cover (FIG. 32). This area represents
the space available for use with a VESA connector plate.
8.
Insert and secure the ten #6-32 securing screws into their pre-drilled holes along the edges of the NXD
unit (FIG. 31). This step secures the NXD unit to the rim of the rear plastic cover.
9.
Align a VESA mount connector (purchased separately) to the four #8-32 screw holes on the back of the
rear plastic cover (FIG. 32).
10.
Insert the four provided #8-32 screws through the VESA mount’s four holes and then into the pre-drilled
holes on the rear plastic cover.
11.
Secure these four #8-32 screws to the rear plastic cover by using a grounded Phillips-head screwdriver.
This step secures the VESA mount to the rear of the panel.
FIG. 32 MB-TP17 Mounting contact surface area
.83[21MM]
1.84[47MM]
4.06[103MM]
3.83[97MM]
When installing a VESA mount to the rear plastic cover, use only the AMX provided
#8-32 screws.
FIG. 33 Installation of grommet into the rear plastic enclosure
Rear plastic cover (rear view)
Rim of the strain relief grommet
should lie flush against enclosure
CLIP FACING UP
VESA mount connection location
(USE ONLY AMX PROVIDED #8-32 screws)