AMF ES-505, Parts And Service Manual, Page: 108 / 146

ES-505
1-94
Released: 01/2018
E-mail: service@amfreece.cz; webside: amfreece.com
Phone: +420 582 309 146; Fax: +420 582 360 606
E - STANDARD MACHINE ADJUSTMENT
21. BOTTOM THREAD AND GIMP TRIMMING - LTT
The bottom thread and gimp is trimmed in clamping
plates area. The clamp feet are released after
trimming.
Procedure :
21.1. Adjust the bottom thread and gimp so that
they are separated at the top and at the bottom with
the guiding plates 1 .
21.2. The leaf springs
3
(bottom thread) and 4
(gimp) hold correct position of the bottom thread
and the gimp is ensured by the grasping fixing plate
2 .
21.3. Loosen the screw 12 . Move the lever 13 to
the end screw 23 . Then set up the distance between
the sliding knife edge 14 and clamp plate edge 7
to 5,5 mm. Tighten the screw 12 .
21.4. Adjust the maximal position of of the operating
rod
9
and the arm
5
with the stopper screw 10 so
that the edge of the fixed knife
6
matches the mark
8
on the knife
7
. Secure the stopper screw with a
nut
11
.