Amada 1000ADP, Operation Manual

Page: 87 / 112

APPENDIX D: COMMUNICATIONS
125ADP/300ADP/1000ADP DUAL PULSE RESISTANCE WELDING POWER SUPPLY
990-922 D-5
ADP Originated Command Set
These are commands returned by the ADP 125, ADP 300, and ADP 1000 to the host computer via the
RS-232 port.
NAME
COMMAND DATA SIZE
TYPE ”TY” Read “ADP”, Release # and Revision #. 14 Bytes
Example:
“ADP 300 1.02 C”.
RESET
“RX” Set Reset an Error, Returns STATUS “TS” 1 Byte
WELD
“TC” Read The current weld counter. 6 Bytes
COUNTER
“TG” Read Good (6 bytes) and Bad (6 bytes) counters. 12 Bytes
LIMITS “TL”
Read Weld count Limit. 6 Bytes
COUNT
“RC” Read Returns # of stored welds. 4 Bytes
REMOTE
”RM” Set <ACK OR NAK> 1 Byte
WELD ZERO “CR” Set
<ACK OR NAK> 1 Byte
WELD LIMIT “CS” Set
<ACK OR NAK> 1 Byte
LOAD
“
LS” Set <ACK OR NAK> 1 Byte
“
LR” Read The active schedule #. 2 Bytes
REPORT ”RR” Read
Schedule #, {1 to 63} 2 Bytes
Weld Status, {0=Good, 1=Out of Limits} 1 Byte
1st pulse Current, 3 Bytes
2nd pulse Current, 3 Bytes
Weld Number. 6 Bytes
15 Bytes Total
REAR
“TR” Read Returns the rear panel status in HEX. 1 Byte
Dual Weld Head (0
th
) 1 Bit
Weld Inhibit (1
st
) 1 Bit
Schedule Lock (2
nd
) 1 Bit
Program Lock (3
rd
) 1 Bit
Emergency Stop (4
th
) 1 Bit
FS2 (5
th
) 1 Bit
FS1 (6
th
) 1 Bit
Fire Switch (7
th
) 1 Bit