Amada 1000ADP, Operation Manual

Page: 100 / 112

APPENDIX F: DEFINING THE OPTIMUM PROCESS
125ADP/300ADP/1000ADP DUAL PULSE RESISTANCE WELDING POWER SUPPLY
F-2 990-922
Alloys are a mixture of two or more metals. An
alloy is normally harder, less conductive, and more
brittle than the parent metal which has bearing on
the type of joint one can expect when resistance
welding a combination of different metals.
Metals atoms are naturally attracted to other
metal atoms even in different parent materials.
Metals and alloys will bond together once
surface contaminants such as dirt, grease, and
oxides removed. Resistance welding generates
heat at the material interface, which decomposes the dirt and grease and helps to break up the oxide film.
The resultant heat softens or melts the metal and the applied force brings the atoms on either side into
close contact to form the bond. The strength of the joint develops as it cools and a new structure is
formed.
There are three main types of bonds that can be formed using the resistance welding process:
•
Solder or Braze Joint
A filler material such as a solder or braze compound is either added during the process or
present as a plating or coating. Soldered joints are typically achieved at temperatures less than
400°C and brazed joints such as Sil-Phos materials melt at temperatures above 400°C.
•
Solid-State Joint
A solid state joint can be formed when the materials are heated to between 70-80% of their
melting point.
•
Fusion Joint
A fusion joint can be formed when both metals are heated to their melting point and their atoms
mix.
Many micro-resistance welding challenges involve joining dissimilar metals in terms of their melting
points, electrical conductivity, and hardness. A solid-state joint can be an ideal solution for these
difficult applications; there is no direct mixing of the two materials across the weld interface thus
preventing the formation of harmful alloys that could form brittle compounds that are easily fractured.
Remember that in a solid-state joint, the metals are only heated to 70-80% of their respective melting
points, resulting in less thermal stress during heating and subsequent joint cooling in comparison to a
fusion weld. As there is no real melting of the materials in a solid-state joint, there is less chance of
weld splash or material expulsion. A weld nugget can still be achieved with a solid-state joint.
Metal B
Metal A
Alloy