Amada 1000ADP, Operation Manual

Page: 22 / 112

CHAPTER 1: DESCRIPTION
125ADP/300ADP/1000ADP DUAL PULSE RESISTANCE WELDING POWER SUPPLY
1-8 990-922
LIMITS / COUNTERS
Press this button momentarily to display the
Limits / Counters
screen. Press and
hold this button for 1 second to display the
Limits / Counters
editing screen.
Welding is
not
allowed when these screens are displayed. Additional instructions
on using the
LIMITS / COUNTERS
screen are in
Chapter 3, Using Display Screens.
Pulse 1 & Pulse 2
Press and hold either of these buttons for approximately 1 second to put the unit
into “edit” mode which allows modification of weld schedule settings.
Press and hold the
Pulse 1
button, waiting for the screen background to change from
BLUE to BLACK . Energy, pulse width, and polarity for Pulse 1 may now be edited.
To accept changes, press the
SAVE
button. To exit “editing” mode
without
accepting changes, press the front panel
RUN
button, then at the
SAVE
prompt, press
the
CLEAR
button to discard.
To edit
Pulse 2
parameters, follow the same procedures described for Pulse 1.
SQZ / HOLD
Pressing this button during edit mode causes the editing highlight to move to the
SQUEEZE
field.
Pressing this button again moves the highlight to the
HOLD
field.
SAVE
Pressing this button saves changes made during editing. Press this button before
turning the unit OFF in order to save
Weld Counter
values and the most recent
weld schedule data.
CLEAR
Press this button to clear the
SQUEEZE
,
HOLD
,
WELD COUNTER
,
COUNTER LIMIT
,
PULSE 1 & PULSE 2 UPPER & LOWER LIMIT
fields. Pressing this button discards
changes made during editing at the
SAVE
prompt: Press
SAVE
to save changes
CLEAR
to discard.