Amada 1000ADP, Operation Manual

Page: 37 / 112

125ADP/300ADP/1000ADP DUAL PULSE RESISTANCE WELDING POWER SUPPLY
990-922 3-1
CHAPTER 3
Using Display Screens
Section I: RUN Screen
RUN Screen
In the lower middle of the screen the
WELD COUNTER
and process monitor indicate how many welds
have been completed since the weld counter was reset and what percentage of those welds were within
programmed limits, indicated both numerically and graphically. The
GREEN bar on the screen above
indicates 95% of welds are within limits, the RED portion of the bar shows 5% of welds are outside
limits.
The
BLUE
RUN
screen is displayed whenever the
Power Supply is in
RUN
mode.
Squeeze and hold times are displayed in the
upper left and right corners of the screen.
Programmed values for energy, pulse width,
weld polarity and upslope are displayed in the
upper middle of the screen.
Weld limits, if any, and the peak weld current
monitor results for the last weld completed are
displayed in the middle of the screen.
The number of the currently active weld
schedule is displayed at the lower right corner.
In the lower middle of the screen the
WELD COUNTER
and process monitor indicate how many welds
have been completed since the weld counter was reset and what percentage of those welds were within
programmed limits, indicated both numerically and graphically. The
GREEN bar on the screen above
indicates 95% of welds are within limits, the RED portion of the bar shows 5% of welds are outside
limits.
The 125APD allows programmed values for
Energy in tenths of watt seconds for energy
settings between 1.0 and 10.0 Ws. The energy
settings for the 125ADP between 10 and 125 Ws
can
only
be set in whole number increments.
The energy settings for the 300ADP and
1000ADP can
only
be set in whole number
increments.
The 125ADP
RUN
screen is the same as the
300ADP and 1000ADP
RUN
screens
except
the
Energy setting is shown with the tenths digit as
shown in the screen shown on the right.