Allied Telesis x510-28GPX, Command Reference Manual

Page: 328 / 2822

C613-50170-01 Rev B Command Reference for x510 Series 328
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
C
ONNECTIVITY
F
AULT
M
ANAGEMENT
C
OMMANDS
CLEAR
(MEP A
TTRIBUTE
)
clear (MEP Attribute)
Overview Use this command to clear a Local MEP attribute.
Syntax
clear {ccm-ltm-priority|lowest-priority-defect|fng-alarm-time
|reset-fng-time|active|all}
Mode Interface Ethernet CFM MEP Configuration
Example To set the active state of the Local MEP to False, use the commands:
awplus(config)# interface port1.0.2
awplus(config-if)# ethernet cfm mep down mpid 12 domain-name
MD-INST2 ma-name MA-INST2-1
awplus(config-if-eth-cfm-mep)# clear active
Related
Commands
ethernet cfm domain-name
ethernet cfm mep
mep (FNG attributes)
service ma-name
Command
changes
Version 5.4.7-1.1: command added
Parameter Description
ccm-ltm-priority
Set the queuing and p-bit priority for CCM messages to their
default value of 7.
lowest-priority-
defect
Set the Fault Notification Generation (FNG) lowest alarm
priority defect to the default value of 2.
fng-alarm-time
Set the Fault Notification Generation (FNG) time for a defect to
be present before an alarm is raised to the default value of 2.5
seconds.
reset-fng-time
Set the Fault Notification Generation (FNG) time for a defect to
abate before an alarm is cleared to the default value of 10
seconds.
active
Set the Local MEP's Active state to the default value of False,
which sets the Local MEP's Administrative State to Down.
all
Set all of the above attributes to their default values.