Allied Telesis x510-28GPX, Command Reference Manual

Page: 1114 / 2822

C613-50170-01 Rev B Command Reference for x510 Series 1114
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
OSPF
V
3
FOR
IP
V
6 C
OMMANDS
IPV
6
OSPF DEAD
-
INTERVAL
ipv6 ospf dead-interval
Overview This command sets the interval during which no hello packets are received and
after which a neighbor is declared dead.
The dead-interval is the amount of time that OSPF waits to receive an OSPF hello
packet from the neighbor before declaring the neighbor is down. This value is
advertised in the router’s hello packets. It must be a multiple of the hello-interval
and be the same for all routers on a specific network.
The no variant of this command returns the interval to the default of 40 seconds.
Syntax
ipv6 ospf dead-interval < 1-65535 > [< inst-id >]
no ipv6 ospf dead-interval
Mode Interface Configuration for a VLAN interface.
Example The following example shows configuring the dead-interval to 10 seconds on the
VLAN interface
vlan2
:
awplus# configure terminal
awplus(config)# interface vlan2
awplus(config-if)# ipv6 ospf dead-interval 10
Related
Commands
ipv6 ospf hello-interval
show ipv6 ospf interface
Parameter Description
< 1-65535 >
The interval in seconds.
Default:
40
< inst-id >
The instance ID
Default:
0